Hyperion EOS 0610inet charger
2 posters
Page 1 of 1
Hyperion EOS 0610inet charger
Hello, I could use some help with a wire location problem. I just started building my own A123 packs, they are 4S1P packs. I decided to install the balance wires while I build each pack. OK the pack is done and I have a female connector for a 4S1P which has 5 wire connections in it. Each wire is labeled on my pack 1 thru 4 and one black wire for ground. My problem is I don't know where to place the ground wire!!
I thought I could determine this by looking at the balance plug in bar that connects to the charger, but I'm not sure. The charger and balance bar can be seen at http://media.hyperion.hk/dn/eos.
I thought I could determine this by looking at the balance plug in bar that connects to the charger, but I'm not sure. The charger and balance bar can be seen at http://media.hyperion.hk/dn/eos.
watersteps- Posts : 1
Join date : 2008-06-01
Re: Hyperion EOS 0610inet charger
The negative wire connects to the ends of the batteries opposite the power leads-on the SPT, you need only solder the wire onto the "gold bar" that connects the two cells.
Dave Matison- Posts : 5
Join date : 2008-06-01
Re: Hyperion EOS 0610inet charger
The negative wire connects to the ends of the batteries opposite the power leads-on the SPT, you need only solder the wire onto the "gold bar" that connects the two cells.
Dave Matison- Posts : 5
Join date : 2008-06-01
Similar topics
» charger question?
» A balancing tap necessary for charging A123 Cells in SPT using AstroFlight charger?
» A balancing tap necessary for charging A123 Cells in SPT using AstroFlight charger?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|